JCIDE

Home Forums Development Kit JCIDE

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by  Chris Shire 1 year, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #320

    Kevin Loveman
    Keymaster

    I’ve had this question from a client: “I had a look at the document debugging info and in point 5 on page 15 it talks about selecting the Run Target.
    If only the Sample Card option is available (which is the case on my installation) you can’t have breakpoints etc. – so basically you can’t debug
    ..
    Says the options available are based on plug-ins and your “commercial use-case”. Could you please investigate how to enable a target that can be used for debugging, otherwise not much use.”

    Any ideas on how to enable debugging on the card?

    #321

    Chris Shire
    Moderator

    This version of the JCard does not support debugging on the card.
    Instead there is a simulator.
    Choosing Run target: “SLJ 52GxxyyyzR Simulator” will launch the simulator, more information can be found in chapter 3 of the “Getting Started” document

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.